Briwax 400g Wax Polish - Antique Pine

Product Information

Can this problem be countered with spray polish or any polish?The answer is no. In our experience, antique or period furniture is only ever finished on the outside; the carcass and drawers are always left unsealed, exposing the wood to the open environment. So spraying the polished exterior with ‘nutrient oils’ will do nothing at all. The best way to try and balance any lost moisture from the wood is by opening the windows and letting the air in. If this is not possible, place a saucer of water underneath or close by it. You could even put a plant in the saucer! Not to be confused with oil based finishes that are convertible coatings (they dry to a hard finish) such as Tung, Linseed and Danish Oil.

It wasn’t until the Georgian times that beeswax for wood became the main form of wood finishing wax. This was because Cabinet makers such as Thomas Chippendale, Sheraton and Hepplewhite, all produced catalogues with new and interesting furniture designs. They were polished using different methods such as French polish and then finished using waxes as a protective layer. This could then maintain the furniture by adding extra layers when necessary as Beeswax never goes bad, it can be heated and reused. Wax was an inexpensive way to maintain furniture. This kind of furniture polish was used throughout the 18 th and 19 th Century and is still used today as it is a non toxic, natural product that acts as a wood polish like no other material. If you feel you need to clean it first you can wipe over the surface with a warm soapy cloth (washing up liquid) and dry it immediately with a dry piece of towelling. How Do I Clean Off The Old Wax Polish On My Furniture? We would struggle to recommend a product because we knew that the ingredients were completely unknown and of such poor quality, also of unknown origin. As a nation we are all much more aware of where products and the ingredients come from, more so than ever before. Antique Furniture Wax is one of the earliest forms of Wood polish on record, used for 100s of years on wood surfaces. Wood Wax was first developed from Beeswax. Beeswax has been around for 1000s of years and is the earliest form of furniture polish, recorded in history. Bees Wax Furniture Polish A good wax polish should have just the right content to provide a thin protective and sacrificial layer to the furniture, adding to the long term preservation and patination of it.The biggest mistake made when wax polishing is buffing the wax off straight after applying it.A good quality brand of wax polish will instruct you to leave the wax to dry on the surface before buffing. The wax needs to evenly coat the surface and dry. Once dry, the wax can be buffed to a soft sheen. You're not rubbing the wax off, you're buffing the wax cells smooth, so they all lie flat on the surface. This allows the light in, to reflect the beautiful wood, at the same time as acting as a naturally enhancing and sacrificial layer. If your tin or can of polish instructs you to apply and then buff after a few minutes or less, you really are doing no more than just wiping it on, and wiping it off. I go into more detail about why these brands recommend this ‘waste of your time’ later on in this article. Polishing With Beeswax: The Correct Way To Buff Moisturising” - It's hard to believe that a spray polish could be moisturising and again this is nonsense. Only when a finish is disintegrating and dried out will a polish be able to ‘moisturise’ the finish, and this will only work with paste wax polishes. Sand the wooden substrate in stages, working with a medium sandpaper (120 grit), through to a medium / fine grade (180 –220 grit). Always sand in the direction of the grain pattern where possible, ensuring the removal of any blemishes and glue residue prior to the application of Fiddes Supreme Wax. Take care to remove all traces of sanding dust and test the chosen Fiddes Supreme Wax shade on a similar substrate to verify the colour. A coat of Fiddes Shellac Sealer is recommended on open grained woods prior to application. On bare or stripped woods, Sand the surface to a smooth finish in the direction of the grain. Stain the wood if necessary. On open grained woods, you can stain and seal using a Shellac Sealer, but this is optional. Apply the Supreme wax using very fine 0000 wire wool or buffing cloth in the direction of the grain and allow soaking into the wood. Remove any excess and then once dry, buff to the desired sheen level. Several coats may be added to build further sheen and protection. This can be used on all bare interior woods or furniture.

The mixture does not contain substances classified as ‘Substances of Very High Concern' (SVHC) = 0.1% published by the European P101 If medical advice is needed, have product container or label at hand.P102 Keep out of reach of children.P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.P271 Use only outdoors or in a well-ventilated area.P501 Dispose of contents/container to … Our restoration customers would often ask us “ How do we look after the furniture once you have restored it?” Historically antique furniture will have been kept in homes where the windows and doors are regularly opened allowing the furniture to maintain its natural moisture level with free flowing air.Apply the polish to manageable areas at any one time, A side of chest, a single leaf or plank of a dining table, one chair or a few drawers at a time. It’s very rewarding to do it this way. Do I Need To Clean My Furniture Before Applying Beeswax Polish? What we consider to be a normal wax finish will be a slightly pigmented light brown coloured wax which will produce a warm mellow finish. Often we can show you a piece which has already been waxed which your chosen piece of furniture will look like once all done. Although pieces of old pine furniture will vary in colour and patina once waxed. The mixture fulfils neither the PBT nor the vPvB criteria for mixtures in accordance with annexe XIII of the REACH regulations EC The spray oil will darken the exposed wood on an old flaky finish, at the same time as attracting dust and dirt.