Hammerite 5092820 Kurust, 250 ml , Blue

Product Information

Rust or corrosion damages metal surfaces and leave dirty, brown spots. Hammerite helps you get rid of rust and revive your metal objects. Follow the guide below if you want to know how to remove rust with Hammerite Kurust: We left sections of 1mm unpainted mild steel to gently corrode outside over the course of several months, then let them thoroughly dry before treating both sides with our products, carefully following the instructions.

Kurust - 250ml - Wilco Direct

Remote areas/Scottish Highlands and non-UK Mainland areas may be subject to additional charges and a longer delivery time. This is determined by our couriers not Rustbuster. Even on the bodywork a stone chip or scratch can soon grow into a nasty blister, and you need to treat rust properly to stop it spreading. Rust removal involves spending hours with a wire brush or strong acidic chemicals that are dangerous to use, so it is far easier and safer to use a rust converter. These stop reaction in the metal using special ingredients, which neutralise the corrosion and allow you to paint over it. The Kurust has definitely transformed the rust and turned it into a really solid surface for painting on. Let’s open the bottle up and see what this stuff looks like, I have never used it before so have no idea what’s inside. Inside The Kurust Bottle Apply by brush directly to the rust. Work well into corners, edges and heavily pitted areas. Avoid applying Kurust to painted areas.

Store locator

So with that in mind, separate off a small amount, you don’t need much. I just used a paint kettle for this. Ready to paint on Painting the Kurust on

Hammerite Paint | Hammerite Metal Paints | Screwfix Hammerite Paint | Hammerite Metal Paints | Screwfix

By brush: apply directly to the rusty area, working well into heavily pitted areas, corners and edges.A handy tub of Hammerite’s popular Kurust rust converter. Transforms rust to a sound surface in 15 minutes, ready for painting in just three hours.

Hammerite Kurust, Rust Treatment, Bottle, 250ml 5092820

Clean the surface by removing all loose paint, rust, dirt, grease and salt. Then rinse with water and let the surface dry. This stuff is really watery so be careful not to splash it everywhere when painting it on. Starting to paint the kurust on Now it starts reactingIf you are getting underneath a car, make sure you use axle stands or ramps and wear eye protection and a mask. Any areas that are holed will need welding, so don’t waste your time with treatment, but surface rust should be rubbed with a wire brush and then painted with a converter. If you are treating a rust bubble on the bodywork, you will want to remove as much of the rust as possible before treating or it will soon reappear under any filler and top coat. here is the rusty metal that I will be painting today. I have wire brushed it and cleaned it as instructed by Hammerite themselves. One side of the steel sample was left unpainted while the other was sprayed with a single coat of primer and acrylic top coat, replicating a typical DIY repair. Once dry, the samples were then doused daily in salty water for four weeks to encourage any corrosion to reappear. We then scored them on ease of use, rust-resisting performance and price. Verdict here’s my bottle of Kurust waiting to be used. The instructions from Hammerite state the following: Special precautions should be taken to avoid inhalation of dust during surface preparation of pre-1960’s paint surfaces as they may contain harmful lead. Caution