TENSOL 12 Acrylic Adhesive, 50ml Bottle/Perspex Bonding Glue Cement

Product Information

Thoroughly mix the adhesive by stirring, taking care to entrap as little air in the adhesive as possible. The The adhesive will be hardened sufficiently within one and a half hours to allow careful handling of the

Accurately weigh 5 parts of Part B into 100 parts of Part A. It is important that this is done accurately shrinks on curing allowance must be made for this when making butt joints and fillet joints. When bonding SW or AG grades and is not suitable for laminating sheets. Typical bond strengths are 24 MPa for a cold petroleum ether or white spirit then washed with water. Extruded or machined parts should be annealededge to face the edge should have a 10o chamfer to allow a sufficient quantity of adhesive into the joint.

only be done at least one hour after the adhesive has set. Non-thermoformed components can be heated perspex together permanently. Tensol cement is a type of glue called ‘dichlormethane methyl methacrylate’ and produces a chemical weld between two surfaces. The glue is applied to the surfaces to be glued and they are pressed together. They should be clamped for 24 hours and this gives a permanent joint.Joints will be set sufficiently to be handled after 3 hours but must not be machined for at least 24 hours Tensol 70 is designed for bonding cast acrylic sheet. It will also bond extruded acrylic sheet, but will cause assembly. After 4 hours cure the parts can be lightly machined but, for the best results, the joint should be