About this deal
Association ensures direct transfer of control commands between devices, is performed without participation of the main controller and requires associated device to be in the direct range. association group – “On/Off (S2)” is assigned to switch connected to the S2 terminal (uses Basic command class).
Double Switch 2 | FIBARO Manuals Single/Double Switch 2 | FIBARO Manuals
The Switch 2 allows for the active power and energy consumption monitoring. Data is sent to the main Z-Wave controller, e.g. Home Center.It is not recommended to associate more than 10 devices in general, as the response time to control commands depends on the number of associated devices. In extreme cases, system response may be delayed. This parameter determines the minimum change in consumed power that will result in sending new power report to the main controller. Applied load and the Switch 2 itself may be damaged if the applied load is inconsistent with the technical specifications! The censors usually appear fairly flat and rectangular. And they have some sort of toggle to allow you to switch the light completely off, to set it to be always on, or to use it with the censor mode.
Wall switch module | Philips Hue UK Hue Wall switch module | Philips Hue UK
While smart switches are usually simply swapped into the same location where a standard wall switch is located, most require a neutral wire connection because a small amount of current flow is necessary for their operation. Thus, it's possible that you will require a circuit upgrade to use these switches.
This parameter determines in what time interval the periodic energy reports are sent to the main controller.