Sentinel X300 System Cleanser 1Ltr

Product Information

For details of how to dose using the Rapid-Dose format of this product, please watch the Rapid-Dose video. It is recommended that Sentinel X300 Cleaner for New Systems is used in accordance with standard cleaning and commissioning protocols such as BSRIA Guide “Pre-Commission Cleaning of Pipework Systems” or similar Water Treatment Guidelines from industry organisations such as the Industrial & Commercial Energy Association (ICOM). As for new systems, X300 Cleaner for New Systems is designed to target installation and manufacture debris and contaminants. Once cleaned, it will passivate the metal surfaces and prevent copper deposition. Sometimes a more general clean is required, aimed at removing iron oxide and limescale deposits from pipework, heat exchangers and radiators. X800 Fast Acting Cleaner is ideal for these purposes, designed for use in conjunction with powerflushing equipment, but also proving a highly effective cleaner when manually flushed, too. It is effective both hot and cold. When might I need Deposit Remover?

How does it work? Contains a specialised dispersant to penetrate and lift sludge. Holds sludge in suspension ready for flushing. How does it work? Acts as an emulsifier for oils and greases and a dispersant to lift and suspend particulate debris. Holds contamination in suspension ready for flushing.Where systems are badly fouled, we recommend a longer circulation period (approximately 3-4 weeks). The product is not aggressive and can be safely left in the system for extended periods. Why? Removes potentially damaging contaminants and restores system effectiveness, reducing future breakdowns and increasing system life. Unrivalled chemical technology reduces circulation time to just 1 hour. litre, 1 300ml aerosol or 1 275ml tube of Sentinel X400 High Performance Cleaner is sufficient to treat a typical domestic system of up to 10 radiators. Larger systems should be dosed with twice this amount.

Apply to: Remove residual flux, grease, oil and manufacturing & installation debris in systems under six months old To clean an older system in accordance with BS 7593, this product should be circulated (preferably at normal operating temperature, with all valves open and the pump turned to maximum flow) for a minimum period of 2 hours or until satisfactory performance is restored. Use in conjunction with a powerflushing device to achieve a more rapid clean. If a system has not been cleaned prior to use, all of the aforementioned issues for new systems will be present, with the installation debris causing issues and damage to the system. Why?A build-up of magnetite sludge and corrosion debris can cause cold spots in radiators and uneven heat distribution. Cleaning an old system before8 installing a new component such as a boiler or circulation pump prolongs the effective life of the new component reducing maintenance and replacement costs. Sentinel X800 Fast Acting Cleaner eliminates magnetite and limescale deposits from heat exchangers, radiators, underflor heating floors and pipework. It restores more uniform distribution of heat in existing installations, for a better heated home and reduced energy bills.

About the problem

If it is not possible to heat the water, the circulation time should be extended to at least 24 hours. After cleaning, the system should be drained and flushed until the water runs clear. On refilling, the system should be treated with Sentinel X100 Inhibitor or Sentinel X500 Inhibited Antifreeze. Apply to: Restore circulation and effectiveness in systems older than six months that have a significant amount of corrosion debris causing poor circulation and cold spots. Prepare for the installation of new components. X300 Cleaner for New Systems is designed to target excess flux residues, greases, and oils in addition to installation debris and sludge. Not only this, but X300 passivates the metal surfaces and helps to prevent copper deposition, a common cause of pinhole corrosion in radiators. Ideally, the product should be added at the first filling of the system. The water should then be circulated at normal operating temperatures for 2 hours before being flushed out. If you are using cold water, leave to circulate for 24 hours. Powerflushing is not necessary when using this product. The system I’m dealing with is not new, but is less than 6 months old