Heater Element for Bosch Washing Machine

Product Information

If your washing machine is kept in a cold, damp room like a garage, outdoor building, shed or conservatory it is more likely to trip the fuse. As you know, electricity and water don’t mix and the damp air from the outbuilding can get into the appliance. It is possible for the water inlet valve to short out but as they are coated in plastic, this is rare. As well as being one of the easiest DIY appliance fixes out there, fixing your washing machine element yourself can save you a lot of money compared to booking a repair or buying a new washing machine. If the leak is slightly smaller and coming from the front, this could be the washing machine door. The seal around the dome can become worn with age, resulting in leaking and/or condensation, but it's easily replaceable. My washing machine is overfilling The conclusion of the user is often that, as the machine doesn’t seem to be washing and they cannot feel any heat in the door or after the wash that the machine is not heating correctly and that this is the cause of the poor results.

However what causes that part to trip the RCD, breaker or fuse is another matter. The most common reason is when the machine has an earth leakage or dead short. This would usually happen every time you turn the machine on. If the fuse trips after the machine has begun filling with water and the drum starts to spin; It could be a fault with the motor.The on and off is normally controlled by (these days) a triac and/or relay on the electronic control board. The control board gets the information to switch it on and off to reach and maintain the temperature via what program you select and when the small thermistor or sensor reports the current water temperature to be.

If you need to replace the element, but are unsure where to start, there’s no need to panic. We’ll talk you through how to successfully replace the element without damaging your washing machine. In this video I will be showing you how to use a megger or insulation tester to help identify problems in a domestic appliance. If it trips straight after filling with water and after the drum has been turning; It could be a fault with the heating element. In some cases, all that you need to do is turn the dial to switch the machine on and the fuse will trip. This can be caused due to any number of components failing when the neutral and live are in one place.If the power to your washing machine won't turn off then your standby button may be faulty. But if the wash cycles won't stop and instead continue after every spin, then it's probably down to the timer or control board. In North America, it’s also common to see machines with two pipes, one for hot and one for cold water. Even these machines may need to further heat water if you choose to wash on a very hot cycle.

Unbalanced washing loads can also create lots of movement. For example, squeezing in eight large bath towels and a bed sheet is too much for a 6kg-capacity washing machine – it's bound to vibrate.Faulty heating – If the machine turns off in the first half hour, the water may not be heating up correctly, which will signal for the machine to stop mid-cycle. On the other hand, if the cycle stops past 30 minutes the water may be overheating, again forcing the cycle to come to a halt. The most likely cause for this is a faulty thermistor. But how do you really know if there is a problem and if your washing machine really is or isn't heating properly? The important thing to understand here and the point is that, if the heater is faulty the machine cannot heat and it will in some way abort the program. This brings us nicely onto a pretty common set or problems that we mentioned earlier, complaints about wash results and the user suspecting that this is down to a fault with the heater. What I have in front of me is a range of elements. We have a grill element, a dishwasher element, two washing machine elements and a fan oven element.