X1 X3 X5 TEST FISH KEY FOR SECRET EMERGENCY LIGHT GRID SWITCHES REPLACEMENT (3) by ToolsOnline

Product Information

This means that the emergency light fitting works with the main lights and is connected to the other lights and is controlled with the normal lighting. When the power fails, the emergency light remains on through the battery which has been charged whilst the mains is on. It can also be turned off whilst the mains is on if it is not needed. The battery often emits around 10% of the normal light levels. Non-Maintained Emergency Lighting Be very careful when touching anything inside the electrical consumer box, there is a danger of electrocution if something is wrong. If in doubt seek a qualified electrician ** What time of day should I test the emergency lights

This depends on the size and complexity of your building and the time it would take to evacuate. The minimum duration for an emergency escape lighting system is one hour. One hour’s duration should only be used if the premises are evacuated immediately on power supply failure and it is not reoccupied until full capacity has been restored to the batteries.Yes and no. If it is a small building and all the emergency lights are on one circuit, then yes, you have no choice. However if it is a large building then it would make sense to stagger the testing. This way the whole building would not be affected if there was a power cut, during the recharge time. Testing Central Battery Systems An Emergency Lighting Certificate is a document that certifies that the emergency lighting system in a building has been installed, tested and commissioned in accordance with the relevant regulations and standards. The certificate is issued by a qualified electrician or contractor who has carried out the installation and testing of the emergency lighting system. They can also provide insights on the suitability of systems in respect of applicable British standards and codes. There are three widely used ways to test emergency lighting. To understand them it is necessary to understand first how an emergency light fitting is wired. Note that the remarks that follow apply to self-contained emergency fittings, not to central battery operated emergency fittings. BS5266-1 states that emergency lighting should be regularly tested. How often should emergency lighting be tested?

These professionals can advise on the steps that need to be taken to determine the extent and details of the emergency lighting system within a particular building. Self-test has several benefits. First, it saves the labour of manual testing. Secondly, it removes the risk that routine monthly or annual testing is overlooked. In my humble opinion the switch should be of "simulation" status IE cutting power (as it would if in a power cut, fire, etc.) and illuminating EL only. It's swings and roundabouts in the building as some areas the key switch shuts off the power to the lights (per room, location) and illuminates the EL. The new refurbished areas the key switch does not cut power to the lights, and with some EL units being part of the main lights this poses a problem to actually see if they are working or not. Yes they have green LEDs in them but you have to look closely to see if they are actually coming on as required. Now the refurbishment on the ground floor seems to be wired up in the 'new' way - does not extinguish power to mains.

Technical Support

We also offer a number of additional services which are available alongside our regular monthly emergency lighting or weekly fire alarm tests.