MICROJIG GRR-Ripper DVC-538K2 Match Fit Dovetail Clamps, Yellow/Green

Product Information

The GTO 1100 and GTO 1600 series are especially remarkable, because they are fully transportable - despite their high instrument load. was looking at a t slot cutting router bit, but the depth needed would be too deep - planing on usual 3/4 material, and these need more to have enough timber above the slot to hold a regular track clamp. By using a dovetail-shaped clamp head, he was able to clamp anywhere he routed a dovetail groove—along the entire fence without limiting it’s height.

Instruments and telescope accessories from "Baader" are known for their high qualities by many astronomers and universities. Important Notice: Use Micro Jig products to improve your safety when machining, they should complement your machine guards not replace them.Invest in the MatchFit Ratchet Clamp AP by Microjig today, and unlock a new dimension in your woodworking journey. Personalised advertising may be considered a “sale” or “sharing” of information under California and other state privacy laws, and you may have a right to opt out. Keep in mind that anyone can view public collections - they may also appear in recommendations and other places. I'm going to make another one soon with some height for vertical boards that I want to pass through my table saw. This clamp fits into the MatchFit Dovetail groove you make using any standard ½” wide, 14 degree dovetail bit.

It’s an entire system designed to give you all the functionality of T-track and T-track accessories, at a fraction of the cost. The bits they supply leave a channel that is not sharp and needs no sanding, if set at the correct depth. Mounting accessories connect telescope and mount - be it for a permanent setup or to make quick changes from one instrument to the next possible.DICTUM is about more than just tools - For more than 170 years, DICTUM has been offering an extensive range of tools, including garden tools, materials, finishes as well as knives for the kitchen and for outdoor use that meet the highest standards and requirements. It’s a design that widens the horizon of your creative possibilities, enhancing your capability and empowering your craft.

When cookies and similar technologies are used, data may also be processed in countries that are not part of the European Economic Area. To the eye they look very very similar, but when you attempt to insert the Matchfit clamp into the underside of the Festool track, it goes in partially (almost to the shoulder) and then stops. This dovetail plate is 350mm long and is useful for installing medium dimensions telescopes (such as refractors up to 120mm and Newton up to 250mm in diameter) on mounts with Losmandy plate (as the SkyWatcher AZ-EQ6, or EQ8). Most clamp arms are free to fall down when released forcing you to reset them every time you secure them, but not Microjig’s Ratchet Clamp. Built to resist vibrations, the MatchFit Ratchet Clamp AP ensures a steadfast setup even during rigorous tasks.Simply slide the X-PAD onto the round cap and you will have a completely new functional level, which allows you to clamp in two directions simultaneously. The PV rating (Peak To Valley) is a measurement from the highest point (Peak) to the lowest point (Valley).