FLOPLAST 50mm x 32mm Grey Pushfit Waste Pipe Reducer

Product Information

When using solvent cement, always work in a well ventilated area and keep the cement away from heat sources or naked flames. relates to the length of the slope, therefore the horizontal projection will vary dependant on the selected roof pitch. Years Guaranteed 10 Type Reducer Thread Size 1 1/4 inch Suitable for Plastic waste pipes, copper pipe and lead pipe Material Polypropylene Diameter 50. Deliveries can take place from as earlier as 07:30 right up to 18:00 depending on the courier/haulier and considering local traffic etc. This product is made to be installed with 56mm (known as 2 inch solvent weld) and 36mm (known as 1 1/4 inch solvent weld) pipe or fittings.

Threshold: This door comes with a standard point; you can upgrade to Low Aluminium Threshold in the options above. This push fit waste system is manufactured in the UK to BS EN 1451 and is British Standard kitemarked. IMPORTANT NOTE: Solvent Weld Waste Pipe fitting sizes are often stated in metric standard measurements, however the actual pipe size is measured in imperial. The product is manufactured using durable ABS, long-life and yet lightweight for ease of installation.The kits are supplied with all the fixings and sealants required for a standard installation and also includes a comprehensive fitting guide. The Polypipe solvent weld waste ABS 32mm and 50mm systems perform at higher operating temperatures than many other waste systems and are strong enough to withstand high impacts. The three options are as follows - 32mm Solvent Weld Pipe actually measure 1 1/4 inchs or 36mm, 40mm Solvent Weld Pipe actually measure 1 1/2 inchs or 43mm, 50mm Solvent Weld pipe actually measure 2 inchs or 56mm.

Designed from the ground up to offer market-leading thermal performance and comfortably meets the requirements of Building Regulations - Part L.As well as the standard lean too configuration the system can be specified as a gable roof design with the wall plates bolted back to back to form a ridge supported between two host walls or as a fee standing option supported on posts. Cost-effective, compact and strong, FloPlast's ABS solvent waste system is the ideal waste solution, suitable for any property or industrial building.

They are used only by Mr Central Heating or the trusted partners we work with, where they are used for marketing, statistics and personalised ads. solvent weld waste fittings are to be used with solvent weld waste pipe with an actual external diameter of 36mm. Apply solvent cement evenly to both surfaces of joint, insert pipe fully into the socket depth and remove surplus cement with a cloth. A leading supplier of plumbing fittings, McAlpine comes with a variety of high-quality and competitive products to suit all plumbing solutions.Solvent weld reducer designed to fit into a larger solvent weld fitting (they cannot be inserted directly into a pipe) and then accept a smaller solvent weld pipe. All our products are manufactured to the highest standards and comply with all current UK and European standards. This unique composite construction creates its class's most thermally efficient folding sliding door. It is recommended that externally installed ABS waste systems are protected against prolonged exposure to sunlight with exterior gloss paint.