VLAND LED Rear lights For 2008-2013 Golf 6 MK6 GTI GTD R TSI Tail Light With Sequential,Red and White,RHD(Driver is on the Right)

Product Information

First, vents along the top and bottom of the headlight housing are necessary to equalize pressure differences that would otherwise cause the entire assembly to crack and fail. In principal the V-Land lights were perfect, no coding and they also has the sequential swoosh indicators (very trick) but I'm not willing to settle for something with a bad fit just to have the LED's. We promise that VLAND can be refunded and replaced if the lights is not artificially modified within one year. I recommend setting aside anywhere from 2-4 hours to install yourself and watch a few YouTube videos.

Read more about the condition New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging is applicable). To understand how to read the volt meter in simple term: When the needle stays constant on high voltage, the wire that was pinch is a Running/Parking light.However after a short time the adapters became commonplace so there must be some RHD suitable ones still in existence. We would like to express our gratitude to Owen McCullough at Edinburgh site for his professionalism, individual support, quick solution of issues.

Lumen headlamps are designed to fit in the exact location of your factory units and cost less than you might think. Fitment is not 100% like OEM lights but its still very high quality I would say about 90-95% the same fitment.

Most standard shipments are sent through local warehouse: United States, Canada, Australia, United Kindom, Germany, France, etc. While most condensation in the headlight lens usually dissipates after approximately 20 minutes of driving with the low beams switched on, some small and insignificant areas of the lens may remain misted for a little longer. For any new part, headlights, or otherwise, it’s always a “best practice” to start by unpacking the components and verifying that everything is in good shape.

If you have had experience working on your own car, you will likely be comfortable performing this task on your own. Once you have the tools you need to rotate the specific adjustment knobs on your headlamp assembly in hand, grab a roll of masking tape and a 25-foot tape measure as well. New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging . I think 15 will now be an option on the drop down menu so no need to manual input it as its the option rosstech the designers of vcds recommend to alot of owners.During the warranty period, Vland will replace or repair, at no charge, a product that is defective in materials or workmanship. Set your OEM headlamp assemblies aside, in the event that you wish to reinstall them one day, for example, if you decide to sell the vehicle.